Paw Print Stud Earring Silicone Mold

This paw print silicone mold has a minimum of 16 cavities allowing you to make at least 16 paw print shaker bits, flatbacks, cabochons, charms or pendants OR at least 8 pairs of stud or dangle earrings.

For 2 part epoxy resin choose either colored or clear silicone. 

For UV resin choose clear silicone. 

All of our resin jewelry molds are 1/8 inch deep, shiny and measured by the longest side. 

Choose from 3 sizes, silhouette or engraved and drilled or non drilled. 

We recommend the following uses.

• 1/2 inch - shaker bits or small stud earrings
• 5/8 inch - stud earrings, small flatbacks or cabochons. 
• 3/4 inch - flatbacks, cabochons, charms, pendants or small dangle earrings. 

The silicone we use is not FDA approved for food use. Use at your own risk. 

Our molds are heat resistant and can be used with polymer clay and low temperature melt alloys.